A practical reference on reconstitution: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-05-06. Anything still debated is marked as such rather than presented as settled.
Melanotan II is a synthetic cyclic heptapeptide that acts as an agonist at melanocortin receptors. It was designed as a structural analogue of alpha-melanocyte-stimulating hormone, the endogenous peptide involved in pigment production. The analogue carries a lactam bridge that constrains the ring and slows enzymatic breakdown relative to the native hormone. In research literature it appears under several abbreviations, and naming conventions are not fully standardized. Published descriptions usually place it within the broader melanocortin agonist family.
Receptor binding at MC1R on melanocytes raises intracellular cyclic AMP and increases expression of tyrosinase and related enzymes. The downstream result is greater synthesis of eumelanin, the dark pigment, without ultraviolet exposure acting as the trigger. The compound is not selective, however, and also engages MC3R, MC4R and MC5R, which are expressed in the central nervous system and elsewhere. That lack of selectivity is the explanation usually offered for effects reported outside pigmentation, including appetite suppression and nausea. Selectivity remains a central theme in comparative studies of related peptides.
Human data remain limited and mostly short-term. Reports describe small trials and observational accounts rather than large controlled studies, so questions about dose-response relationships and long-term effects on melanocytes stay open. Whether repeated exposure alters naevus behaviour is not settled in the published record. Researchers also note that self-administered use outside clinical settings makes actual exposure difficult to quantify. Statements about efficacy and safety should therefore be read as preliminary rather than established.
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
Regulatory treatment varies by country. In the United States the peptide is not approved as a medicine, and products offered for human use may be treated as unapproved new drugs; some states also restrict sale. Australia, the United Kingdom, and European Union member states apply comparable restrictions to unapproved peptide products. Border agencies have seized shipments labelled as research chemicals. Classification may change over time, and the legal position for personal importation is not clearly settled in most published guidance.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Synthetic cyclic heptapeptide | Melanocortin receptor agonist |
| Molecular formula | C50H69N15O9 | Neutral form, mass near 1024.2 g/mol |
| Primary targets | MC1R, MC3R, MC4R, MC5R | Binding is non-selective across subtypes |
| Related compounds | Alpha-MSH, melanotan I, afamelanotide | Structurally or functionally related peptides |
| Common abbreviations | MT-II, MT-2 | Naming in the literature is not uniform |
Melanotan-2, also written Melanotan II, is a synthetic cyclic heptapeptide designed as an analogue of alpha-melanocyte-stimulating hormone. Its sequence is Ac-Nle-cyclo[Asp-His-D-Phe-Arg-Trp-Lys]-NH2, and the lactam bridge between the aspartate and lysine side chains constrains the peptide into a ring. This structural change increases receptor affinity and metabolic stability relative to the native hormone. The compound was created in the 1980s as a research tool for studying pigmentation biology.
Melanocytes are the pigment-producing cells of the skin, and they carry melanocortin-1 receptors on their surface. When the receptor is activated, cyclic adenosine monophosphate rises inside the cell and raises the activity of enzymes such as tyrosinase, which increases melanin output. Melanotan-2 binds melanocortin-1 receptors in vitro and in animal models, and this binding is generally described as the basis for the tanning effect. Other receptors account for different effects: melanocortin-4 receptors contribute to appetite and erectile signalling, while melanocortin-3 and melanocortin-5 receptors contribute to energy balance and exocrine function.
Lyophilized peptide powder is generally stored frozen, protected from light and moisture. Tryptophan residues are susceptible to oxidation, and the lactam bridge can hydrolyze under strongly acidic or basic conditions. Solutions prepared for laboratory work degrade faster than dry powder, and repeated freeze-thaw cycles accelerate loss. Common practice is to aliquot solutions before freezing and to avoid alkaline buffers. Reported stability windows vary with concentration, buffer, and temperature, so exact shelf lives are method-specific rather than universal.
Regulatory status differs by country, and in many places supplying the compound for human consumption is unlawful. Vendors frequently label material as intended for research use only, a designation that shifts stated purpose but does not create a legal pathway for personal use. Certificates of analysis accompanying such products vary widely in detail and provenance. Third-party testing exists but is voluntary, and results are rarely linked to a specific lot in a publicly verifiable way.
== Structure == Glutathione reductase from human erythrocytes is a homodimer consisting of 52kDa monomers, each containing 3 domains. GR exhibits single sheet, double layered topology where an anti-parallel beta-sheet is largely exposed to the solvent on one face while being covered by random coils on the other face. This includes and NADPH-binding Domain, FAD-binding domain(s) and a dimerization domain. Each monomer contains 478 residues and one FAD molecule. GR is a thermostable protein, retaining function up to 65 °C.
Although orphan disease populations are the smallest, the cost of per-patient outlays among them are the largest and are expected to increase as more people with rare diseases become eligible for subsidies – in the U.S., for example, through the Affordable Care Act.
==== Writers and Erasers ==== The proteins that regulate genetics are often categorized as writers, readers, and erasers, i.e., enzymes that install epigenetic modifications, proteins that recognize these modifications, and enzymes that remove these modifications. To date, O-GlcNAc has been identified on writer and eraser enzymes. O-GlcNAc is found in multiple locations on EZH2, the catalytic methyltransferase subunit of PRC2, and is thought to stabilize EZH2 prior to PRC2 complex formation and regulate di- and tri-methyltransferase activity. All three members of the ten-eleven translocation (TET) family of dioxygenases (TET1, TET2, and TET3) are known to be modified by O-GlcNAc. O-GlcNAc has been suggested to cause nuclear export of TET3, reducing its enzymatic activity by depleting it from the nucleus. O-GlcNAcylation of HDAC1 is associated with elevated activating phosphorylation of HDAC1.
Sources: en.wikipedia.org
== Pathology == Mutations in the PLOD1 gene have been linked to kyphoscoliotic Ehlers–Danlos syndrome (kEDS, in the past EDS VI).Mutations in the PLOD2 gene have been linked to Bruck syndrome in humans. A deficiency in its cofactor vitamin C is associated with scurvy.
Interestingly, most of these mutations lead to exon skipping, and produce a shorter polypeptide, in which the Gly-Xaa-Yaa triplets stay in frame and there are no premature termination codons. Although vEDS is typically inherited in an autosomal-dominant manner, rare individuals with biallelic (homozygous or compound-heterozygous) COL3A1 variants – frequently null alleles – have an autosomal-recessive form of the disorder. The functional consequences of COL3A1 mutations can be studied in a cell culture system. A small punch biopsy of skin is obtained from the patient and used to start the culture of skin fibroblasts which express type III collagen. The type III collagen protein synthesized by these cells can be studied for its thermal stability. In other words, the collagens can be subjected to a short digestion by proteinases called trypsin and chymotrypsin at increasing temperatures. Intact type III collagen molecules, which have formed a stable triple helix, can withstand such treatment till about 41 °C, whereas molecules with mutations that lead to glycine substitutions fall apart at a much lower temperature. It is difficult to predict the clinical severity based on the type and location of COL3A1 mutations. Another important clinical implication is that several studies have reported on mosaicism. This refers to a situation where one of the parents carries the mutation in some, but not all of her or his cells, and appears phenotypically healthy, but has more than one affected offspring.
== Overview == FACIT collagens have interruptions in their triple helical structure. They are involved in assembling fibrillar collagens and other ECM components. Interruptions in the triple helical structure of FACIT collagens occur due to the presence of non-triple helical domains within the collagen molecule. These collagens are typically found alongside fibrillar collagens in various tissues and organs. Fibril-associated collagens with interrupted triple helices (FACIT collagens) are a subset of collagens that contribute to the organization and stabilization of the extracellular matrix (ECM). These collagens are typically found alongside fibrillar collagens in various tissues and organs. These domains vary in length and composition and provide flexibility and additional binding sites for other components of the extracellular matrix. There are eight known types of FACIT collagens: collagens IX, XII, XIV, XVI, XIX, XXI, and XXII. The general FACIT collagen structure contains short triple helical COL domains (COL1, COL2, COL3) interrupted by NC domains with an N-terminal NC domain facing toward the interfibrillar space. FACIT collagen is found in various tissue areas to modulate the surface properties of collagen fibrils and generate tissue-specific three-dimensional patterns in the extracellular matrix. For example, collagen XIV connects the fibrillar networks of the cartilage and skin, and XII is found in connective tissues, particularly at the tendons, ligaments, and periodontium.
Sources: en.wikipedia.org
It is a synthetic cyclic heptapeptide and a non-selective melanocortin receptor agonist. Structurally it is modelled on alpha-melanocyte-stimulating hormone, a peptide that occurs naturally in the body.
Activation of MC1R increases pigment synthesis independently of ultraviolet exposure, which is the mechanism usually cited for darkening without sun exposure. Ultraviolet light still influences skin response through separate biological pathways.
Because the peptide binds several melanocortin receptor subtypes, its effects are not confined to pigmentation. This complicates interpretation of both intended and unintended outcomes reported in studies.
Low temperature slows hydrolysis and oxidation, the two main routes by which the peptide backbone and side chains are modified. A lyophilised powder stored at −20 °C is more stable than one kept at room temperature, and once the material is dissolved the degradation rate rises, making refrigeration more important.